Table of Contents
Advertisement
Install The Parts
After the air strainer is maintained,be sure to install it
following the sequence 1～2.
When other parts are handled,please follow the installation
methods for each of them.
Air strainer (2 on each side)
<Location of the air strainer>
Left side
Right side
End
Surface
Surface
Vertical vanes
Insert along the upper side of the
air vane
Finally
1. Insert the power supply plug.
2. Press the
button on the remote controller,and the unit will start running.
The side of the air filter where
there are letters faces outward
and is inserted into the bottom
along the strainer guide rail.
The end is inserted in place.
Horizontal vanes (upper left,upper right,lower
left,upper left,4 pieces)
When maintenance is being done,for
the sake of safety,please pull out the
power supply plug or cut off the power
supply.
Panel
1.Close
2.Hold 3 places
If the panel is not installed,there will be abnormal
sound during operation.
Be installed in the specified location.
Install them in the sequence of
lower first and then the upper ones.
Move the safety stopper along the
direction it is installed until the click
sound is heard.
If the safety stopper is not installed properly,
all the indicators will flicker and the unit can't
be started.
Lock the locking device.
21
Advertisement
Chapters
Table of Contents
