Part Maintenance - Mitsubishi Electric MSZ-AH09VA-H1 Operating And Installing Instructions

Part Maintenance

Please follow the sequence 1～2 to handle the air strainer.
If you find the strainer is dirty,please maintain (clean) it.
When other parts are handled,please follow the methods
for removing each of them.
Front panel
Open the panel by fastening it with hands
and turn it to the support location
Do not step onto an unstable bench when handling
the unit.This may cause injury if you fall down.
Horizontal vanes (4 pieces in total:upper left,lower left,
upper right,lower right)
1
Open the vane downward
2
Use a screwdriver to loosen the locking device of the safety
stopper on the vanes
3
Remove the safety stopper along the direction of the arrow
4
Draw out the vanes
Please open the vane gently and slowly,or
damage may be caused to related parts.
Locking device
锁住 松开
The 4 pieces of vanes mentioned above are
respectively removed by following steps ①
～④.When they are removed,follow the
sequence of upper first and then lower.
When the unit is to be handled,for the
sake of safety,please disconnect the
power supply plug or cut off the power
supply.
Air strainer (2 on each side)
Hold the handle of the strainer,raise it slightly
and then draw it outward.
Vertical vanes
5
6
拆下 装上
Draw it out in the direction of
the arrow by pressing the
handle
19