Turning The Power On/Off - Furuno CI-68 Operator's Manual

1. OPERATIONAL OVERVIEW

1.2 Turning the Power On/Off

1. Press the [POWER] switch at the left hand side of the control unit to turn the power on. A
beep sounds, the equipment turns on, and the lamp above the switch lights. The
equipment conducts the diagnostic test to check for proper operation between the
transceiver unit and the control unit and displays the results. After the diagnostic test is
completed the last-used display appears.
CI-68
CI-6888
VOL. 6651000-XX.XX
MEM. 1
CI-6810
VOL. 6651001-XX.XX
TBL.
MEM. 1
ANA.12V;12.03V
TRM.
DSW.
Note: The example screens shown in this manual may not match the screens you see
on your display. The screen you see depends on your system configuration and
equipment settings.
2. To turn the power off, press the [POWER] switch again.
Note: The NAV mode measures tides in deep waters where ground tracking is not available.
To use this function effectively, accurate heading data (from a gyrocompass, satellite
compass) is necessary. For further details, see page AP-3.
1-2
2 3 OK
2 3 4 5 6 7 8
BV; 110.0V
+25.02 ° C
Diagnostic test
OK