Epson Stylus Pro 7800 Printer Manual page 19

Note: Make sure you
tighten all bolts before
moving to the next
section.
2. Insert the right leg into the right base as shown. (Note that the bases are
labeled and ) Use the included hex wrench to fasten the leg with the
L R.
two base bolts.
3. Assemble the left leg and base in the same way.
4. Attach the bottom horizontal strut as shown, then fasten it with one
collar and one strut bolt at each end. Make sure the bolts are tight.
1-19
Setting Up the Printer
Bolt holes
Underside view of base
showing location of bolt holes
Collar
Strut bolt
| 19