Connecting External Devices; Devices Connection - Honeywell Performance Series User Manual

Connecting External Devices

1. Connect the cameras
2. Connect the monitor
3. Connect the mouse
4. Connect the Ethernet cable
5. Connect audio devices (if applicable)
6. Connect alarm devices (if applicable)
7. Connect a PTZ camera (if applicable)
8. Connect the power cable

Devices Connection

The following diagram shows a typical NVR connection:
18
Connect the coaxial cables from the cameras to the VIDEO IN
connectors (1 Vp-p, 75 ohm).
Connect a VGA cable (not supplied) to the VGA interface and/or an
HDMI cable (not supplied) to the HDMI interface. Connect the
other end to a monitor (do not use a TV). Simultaneous VGA and
HDMI output is supported.
Connect the supplied USB mouse to the USB 2.0 interface.
Connect the supplied CAT5e Ethernet cable to the network port.
Connect the other end to a router on your network.
To record audio, connect the audio sources to the AUDIO IN
connectors. To play audio, connect an audio output device (low-
impedance headphones, speaker, or amplifier) to the AUDIO OUT
connector (200 mV / 1 kilohm).
Connect alarm devices to the alarm in/out interface. If the alarm
inputs use external power, the device must have the same ground
as the NVR.
Your embedded NVR communicates with PTZ cameras through the
Network. Ensure that you camera is correctly connected to the
Network.
Connect the supplied 12 V DC power adapter to the power input.
Use of an uninterruptible power supply (UPS) is strongly
recommended.
Performance Series Embedded NVR User Guide