Snmp; Table 35 Email Parameters - Honeywell Performance Series User Manual

2. Configure the settings for the email parameters.

Table 35 Email Parameters

Parameter
Enable
SMTP Server
Port
Username
Password
Anonymous
Receiver
Email Address
Sender
Subject
Attachment
Encryption Type
Interval (Sec.)
Health Mail
Sending Interval
Test
3. Click Apply to complete the settings.

SNMP

You can connect the Device with some software such as MIB Builder and
MG-SOFT MIB Browser to manage and control the Device from the
software.
Performance Series Embedded NVR User Guide
•
Install the software that can manage and control the SNMP,
such as MIB Builder and MG-SOFT MIB Browser
•
Obtain the MIB files that correspond to the current version from
Description
Enable the email function.
Enter the address of SMTP server of sender's email account.
Enter the port value of SMTP server. The default value setting is
25. You can enter the value according to your actual situation.
Enter the username and password of sender's email account.
If enable the anonymity function, you can login as anonymity.
In the Receiver list, select the number of receiver that you want to
receive the notification. The Device supports up to three mail
receivers.
Enter the email address of mail receiver(s).
Enter the sender's email address. It supports maximum three
senders separated by comma.
Enter the email subject.
Supports Chinese, English and Arabic numerals. It supports
maximum 64 characters.
Enable the attachment function. When there is an alarm event, the
system can attach snapshots as an attachment to the email.
Select the encryption type: NONE, SSL, or TLS.
For SMTP server, the default encryption type is TLS.
This is the interval that the system sends an email for the same
type of alarm event, which means, the system does not send
emails caused by frequent alarm events.
The value ranges from 0 to 3600. 0 means that there is no interval.
Enable the health test function. The system can send a test email
to check the connection.
This is the interval that the system sends a health test email.
The value ranges from 30 to 1440. 0 means that there is no
interval.
Click Test to test the email sending function. If the configuration
is correct, the receiver's email account will receive the email.
Before testing, click Apply to save the settings.
65