Figure 119 Tour; Table 52 Tour Setting Parameters - Honeywell Performance Series User Manual

Figure 119 Tour

•
•
2. Configure the tour setting parameters.

Table 52 Tour Setting Parameters

Parameter
Enable Tour
Interval
Motion Tour, Alarm
Tour
Live Layout
Channel Group
3. Click Apply to save the settings.
106
On the top right of the live view screen, use the left mouse button
or press Shift to switch between
and (image switching is not allowed) to turn on/off the tour
function.
On the navigation bar, click
disable it.
Description
Enable tour function.
Enter the amount of time that you want each channel group displays
on the screen. The value ranges from 5 seconds to 120 seconds, and
the default value is 5 seconds.
Select the View 1 or View 8 for Motion Tour and Alarm Tour (system
alarm events).
In the Live Layout list, select View 1, View 4, View 8, or other modes
that are supported by the Device.
Display all channel groups under the current Window Split setting.
•
•
•
•
Performance Series Embedded NVR User Guide
(image switching is allowed)
to enable the tour and click
Add a channel group: Click Add, in the pop-up Add Group
channel, select the channels to form a group, and then click Save.
Delete a channel group: Select the check box of any channel
group, and then click Delete.
Edit a channel group: Select the check box of any channel group
and then click Modify, or double-click on the group. The Modify
Channel Group dialog box is displayed. You can regroup the
channels.
Click Move up or Move down to adjust the position of channel
group.
to