Figure 55 Ptz-Tour; Figure 56 Ptz-Pattern - Honeywell Performance Series User Manual

2. Click the Tour tab.

Figure 55 PTZ-Tour

3. In the Tour No. box, enter the value for the tour route.
4. In the Preset box, enter the preset value.
5. Click Add Preset.
Note:
Configuring Patterns
1. On the expanded PTZ control panel, click
2. Click the Pattern tab.

Figure 56 PTZ-Pattern

3. In the Pattern box, enter the value for pattern.
4. Click Start to perform the directions operations. You can also go to
Performance Series Embedded NVR User Guide
The PTZ interface is displayed.
The Tour tab is displayed.
A preset will be added for this tour.
You can repeat adding more presets.
•
Click Delete Preset to delete the preset for this tour. This operation
•
can be repeated to delete more presets. Some protocols do not
support deleting.
The PTZ interface is displayed.
The Pattern interface is displayed.
the PTZ Control Panel to perform the operations of adjusting
.
53