Getting Started; Unpacking The Nvr; Connecting External Devices - Honeywell Performance Series User Manual

2 Getting Started

This chapter contains the following sections:
•

Unpacking the NVR

•

Connecting External Devices

•
Starting and Shutting Down the NVR
•
Device Initialization
•
Reset Password
•
Setting Up the NVR with the Startup Wizard
•
Setting Up Bi-Directional Communication Connection
Unpacking the NVR
Before you set up the NVR, make sure that you have received the following items:
• Quick Installation Guide
• Quick Networking Guide
• Software CD
• Power adapter and cable
• Mouse
If any of the items listed above are missing or damaged, contact your Honeywell dealer
immediately.
Connecting External Devices
Step 1: Connect the cameras
Connect the coaxial cables from the cameras to the VIDEO IN connectors (1 Vp-p, 75 ohm).
Step 2: Connect the monitor
Connect a VGA cable (not supplied) to the VGA interface and/or an HDMI cable (not supplied)
to the HDMI interface. Connect the other end to a monitor (do not use a TV). Simultaneous
VGA and HDMI output is supported.
Step 3: Connect the mouse
Connect the supplied USB mouse to the USB 2.0 interface.
on page 11.
on page 11.
on page 16.
on page 17.
on page 19.
on page 21.
on page 24.
• Remote control
• CAT5e network cable
• Terminal block connectors (×2)
• Screws (×10)
• Serial ATA (SATA) cable*
Getting Started
11