Prevent Damage From Chemical Supplies And Chemical Systems; How Chemical Supplies Can Cause Damage; Dangerous Chemical Supplies And Wash Formulas - Milnor 30022X8R Maintenance Manual

WARNING: Entangle and Crush Hazards — Contact with moving components nor-
out is called for in the service instructions. Outside the USA, abide by the OSHA standard
in the absence of any other overriding standard.
WARNING: Confined Space Hazards — Confinement in the cylinder can kill or injure
BIWUUI03 / 2019296
2.2 Prevent Damage from Chemical Supplies and
Chemical Systems
All Milnor ® washer-extractors and CBW
specification. This material gives good performance when chemical supplies are correctly ap-
plied. If chemical supplies are incorrectly applied, this material can be damaged. The damage can
be very bad and it can occur quickly.
Chemical supply companies usually:
• supply chemical pump systems that put the supplies in the machine,
• connect the chemical pump system to the machine,
• write wash formulas that control the chemical concentrations.
The company that does these procedures must make sure that these procedures do not cause dam-
age. Pellerin Milnor Corporation accepts no responsibility for chemical damage to the ma-
chines it makes or to the goods in a machine.
2.2.1

How Chemical Supplies Can Cause Damage

Dangerous Chemical Supplies and Wash Formulas

can cause damage are:
• a very high concentration of chlorine bleach,
• a mixture of acid sour and hypo chlorite,
• chemical supplies (examples: chlorine bleach, hydrofluosilicic acid) that stay on the stainless
steel because they are not quickly flushed with water.
Pellerin Milnor Corporation
mally isolated by guards, covers, and panels, can entangle and crush your
limbs. These components move automatically.
Do not service the machine unless qualified and authorized. You must
�
clearly understand the hazards and how to avoid them.
Abide by the current OSHA lockout/tagout standard when lockout/tag-
�
you. Hazards include but are not limited to panic, burns, poisoning, suffo-
cation, heat prostration, biological contamination, electrocution, and
crushing.
Do not enter the cylinder until it has been thoroughly purged, flushed,
�
drained, cooled, and immobilized.
® tunnel washers use stainless steel with the ANSI 304
BNUUUR02 0000160550 E.3
BNUUUR02.C01 0000160549 A.6 E.3 B.3 1/2/20 2:14 PM Released
BNUUUR02.R01 0000160548 A.6 E.3 B.5 10/1/21 11:24 AM Released
— Some examples that
Safety
1/2/20 2:14 PM Released
9