Primary Information Sources; Prevent Damage From Chemical Supplies And Chemical Systems; Figure 9 How Rotating Forces Act On The Foundation - Milnor MWF36J8 Installation Manual

Figure 9. How Rotating Forces Act On the Foundation
A... Direction of force
B... Load
C... Rotation (frequency = RPM / 60)
NOTE: This figure applies to both rigid and suspended washer-extractors and to both
at-grade and upper floor installations.
2.2.3

Primary Information Sources

Milnor ® provides, or can provide the following information of use to engineers and architects, for
the given machine model:
• The machine dimensional drawing, found in the installation manual, specifies the machine's
required anchorage.
• The Milnor ® Service Department can provide static and dynamic load values and frequency
(extract speed) values on request.
NOTICE: All data is subject to change without notice and may have changed since last
printed. It is the responsibility of the potential owner/operator to obtain written confirma-
tion that any data furnished by Milnor
ber(s) of the purchased machine(s).
BIWUUI03 / 2019296
2.3 Prevent Damage from Chemical Supplies and
Chemical Systems
All Milnor ® washer-extractors and CBW
specification. This material gives good performance when chemical supplies are correctly ap-
plied. If chemical supplies are incorrectly applied, this material can be damaged. The damage can
be very bad and it can occur quickly.
Chemical supply companies usually:
• supply chemical pump systems that put the supplies in the machine,
Pellerin Milnor Corporation
Typical Washer-extractor (see note below)
Legend
® applies for the model number(s) and serial num-
® tunnel washers use stainless steel with the ANSI 304
Important Installation Precautions
BNUUUI01.C04 0000189357 B.2 A.5 C.3 1/2/20, 2:14 PM Released
BNUUUR02 0000160550 E.3
BNUUUR02.C01 0000160549 B.2 B.3 E.3 1/2/20, 2:14 PM Released
1/2/20, 2:14 PM Released
39