Thermistor Troubleshooting - Carrier 48/50PD05 User Manual

Thermistor Troubleshooting

The electronic control uses thermistors to sense temperatures used
to control operation of the unit. Resistances at various temperatures
are listed in Table 15- -17. Thermistor pin connection points are
shown in the Major System Components section. The general
locations of the thermistors are shown the Major System
Components section.
Air Temperatures
Air temperatures are measured with 10 kilo-ohm thermistors. This
includes supply-air temperature (SAT), outdoor-air temperature
(OAT), space temperature sensors (T55, T56, T58), and return air
temperature (RAT).
The supply air temperature (SAT), return air temperature (RAT)
and outdoor air temperature (OAT) thermistors use a snap-mount to
attach through the unit sheet metal panels. The snap-mount tabs
must be flattened on the tip end of the sensor to release for removal
from the panel. (See Fig. 10.) To reinstall, make sure the
snap-mount tabs extend out.
Fig. 10 - - SAT, RAT and OAT Thermistor Mounting
Refrigerant Temperatures
Condenser coil temperatures are measured with 5 kilo-ohm
thermistors. These measurements provide an approximate saturated
condensing temperature for each circuit (SCT.A). Fig. 11 shows
the factory locations for the SCT thermistors on 48/50PD units.
Ensure that thermistors are placed at the correct location and are
snapped securely over the return bend so that contact is made
between the thermistor and the tube.
Fig. 11 - - Saturated Condensing Temperature Thermistor
Thermistor/Temperature Sensor Check
A high quality digital volt-ohmmeter is required to perform this
check.
Connect the digital voltmeter across the appropriate thermistor
terminals at the J8 terminal strip on the Main Base Board (see
Major System Components section).
Using the voltage reading obtained, read the sensor temperature
from Table 15- -17.
To check thermistor accuracy, measure temperature at probe
location with
temperature-measuring instrument. Insulate thermocouple to avoid
ambient temperatures from influencing reading. Temperature
measured by thermocouple and temperature determined from
C07015
thermistor voltage reading should be close, within 5°F, if care was
taken in applying thermocouple and taking readings.
If a more accurate check is required, unit must be shut down and
thermistor removed and checked at a known temperature (freezing
point or boiling point of water) using either voltage drop measured
across thermistor at the J8 terminal, or by determining the
resistance with unit shut down and thermistor
J8. Compare the values determined with the value read by the
control in the Temperatures mode using the Scrolling Marquee
display.
37
Location
an accurate thermocouple-type
disconnected from
C07016