Configuring Your Computer For The First Time; Examine Switches Or Print Report - Acer Altos 900 User Manual

5.4 Configuring Your Computer for the First
Time
Follow these steps when configuring your computer for the first time:
1. Select Step 1: Important EISA Configuration Information from the ECU
main menu. Read through the information then press F10 when you are
done.
2. Select Step 4: Examine switches or print report, then press Enter to display
the screen shown below.
Step 4: Examine switches or print report
You must PHYSICALLY verify that the switches and jumpers
of each board marked with an arrow ( → ) are set as
required. These settings cannot be detected or changed by
this program.
To view the required settings for the highlighted
board, press ENTER.
settings to the required settings.
settings to match the required settings.
> System AcerAltos Server
Slot 1 (Empty)
Slot 2 (Empty)
Slot 3 (Empty)
Embedded PCI SCSI Controller
>View=ENTER< <Print=F7>
Figure 5-7 Examine Switches or Print Report
3. Notice the boards marked with an arrow on the screen, if any. The arrow
indicates that the boards in your computer may have defined jumpers and
switches that you must physically verify. It may also mean that there is a
software statement with additional information about the board.
AcerAltos 900 User's Guide
5-12
Pick up the board and compare its
Change the board
<Done=F10>