Table of Contents
Advertisement
4.
Read through the information then press
5.
Select Step 4: Examine switches or print report, then press
screen.
Step 4: Examine switches or print report
Step 4: Examine switches or print report
You must PHYSICALLY verify that the switches and jumpers of each
board marked with an arrow ( → ) are set as required. These settings
cannot be detected or changed by this program.
To view the required settings for the highlighted board, press ENTER.
Pick up the board and compare its settings to the required settings.
Change the board settings to match the required settings.
System
PCI 1
(Empty)
PCI 2
(Empty)
PCI 3
(Empty)
PCI 4
(Empty)
OB SCSI
PCI SCSI Controller
EISA 1
(Empty)
EISA 2
(Empty)
EISA 3
(Empty)
>View=ENTER<
<Print=F7>
Figure 6
Examine Switches or Print Report
6.
Notice the boards marked with an arrow on the screen, if any. The arrow indicates that the
boards in your computer may have defined jumpers and switches that you must physically
verify. It may also mean that there is a software statement with additional information about
the board.
7.
To view the switch and jumper settings, highlight the board marked with an arrow and press
. The switch/jumpers settings screen for the board appears.
8.
Scroll through the switch and jumper settings for the board, and press
finished viewing the information.
9.
To print the information, select Print by pressing
Select desired direction:
Print settings for selected board or option
Print settings for selected board or option to a file
Print all configuration settings
Print all configuration settings to a file
>Select=ENTER<
Figure 7
Print Settings
P/N 46.AA983.002
Server
<Done=F10>
Print Settings
<Printer Setup=F8> <Cancel=ESC>
(10 of 22)
when you are done.
. The Print Settings screen appears.
to display the following
when you have
August 22, 1997
Advertisement
Table of Contents
