Boot Device Options Screen - Acer Altos 900 User Manual

Adaptec AIC7880 Ultra/Ultra W
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID ...................................7
SCSI Parity Checking....................................Enabled
Host Adapter SCSI Termination ....................Low ON/High ON
Additional Options
Boot Device Options......................................Press <Enter>
Please run SCSI Disk Utilities to get present devices
SCSI Device Configuration............................Press <Enter>
in your system
Advanced Configuration Options...................Press <Enter>
Boot Target ID...................................................................................
-----------Options Listed Below Have NO EFFECT if Multiple Lun Support is Disabled-------------
Boot Lun Number.............................................................................. 0
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 4-6 Boot Device Options Screen
SCSI Device Configuration
This option allows you to configure certain parameters of each SCSI device on the
SCSI bus. A screen similar to Figure 4-7 appears. The screen shows a column of
information for each SCSI ID, even if some SCSI IDs are not assigned to a device.
To configure a specific SCSI device, you need to know which SCSI ID it uses. See
SCSI Disk Utilities later in this section to learn how to determine which SCSI ID is
used by which device.
AcerAltos 900 User's Guide
4-10
SCSISelect (TM)
AIC-7880 Ultra/Ultra W at Bus:Device 00:10h
Boot Device Configuration
<F6> - Reset to Host Adapter Defaults
Utility v1.2
0
* =default)