Table of Contents
Advertisement
Use the cursor ( ↑ ↓ ) to move to your selection. Press Enter to display a pop-up
menu of choices or to make selections. Press Esc at any time to return to the
previous menu.
Press F6 to reset all settings to the SCSI
controller defaults. SCSI controller default
settings are marked with an asterisk (*)
throughout the selection submenus.
Host Adapter SCSI ID
This option allows you to change the host controller SCSI ID. Figure 4-3 shows
the available IDs for use with the AIC-7880. The default setting is SCSI ID 7. (We
recommend that you not change this setting.) Some operating system software
will not run unless the SCSI controller ID is set at ID 7.
Adaptec AIC7880 Ultra/Ultra W
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID ...................................7
SCSI Parity Checking....................................Enabled
Host Adapter SCSI Termination ....................Low OFF/High ON
Additional Options
Boot Device Options......................................Press <Enter>
SCSI Device Configuration............................Press <Enter>
Advanced Configuration Options...................Press <Enter>
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 4-3 Host Adapter SCSI ID Selection Screen for AIC-7880
AcerAltos 900 User's Guide
4-6
SCSISelect (TM)
0
AIC-7880 Ultra/Ultra W at Bus:Device 00:10h
1
2
3
4
5
6
7
*
8
9
10
11
12
<F6> - Reset to Host Adapter Defaults
13
14
15
Utility v1.2
*
=default)
Advertisement
Table of Contents
