Table of Contents
Advertisement
3.4.1 PCI IRQ Setting
This parameter allows for Auto or Manual configuration of PCI devices. If you
use plug-and-play (PnP) devices, you can keep the default setting Auto. The
system then automatically configures the PnP devices. If your PCI device is not a
PnP, you can manually assign the interrupt for each device. Refer to your manual
for technical information about the PCI card.
If you set this parameter to Manual and you
enabled the onboard SCSI, make sure that
you assign the onboard SCSI IRQ to PCI
Slot 4.
PCI Slots
These parameters allow you to specify the appropriate interrupt for each of the
PCI devices. You can assign IRQ3, IRQ4, IRQ5, IRQ7, IRQ9, IRQ10, IRQ11,
IRQ12, IRQ14, or IRQ15 to the slots.
To avoid conflicts, make sure that the
interrupt you assign in any of the PCI slots is
not used by other devices.
If a PCI card is added to PCI slot 4, it must
be capable of sharing an IRQ with the
onboard SCSI controller.
w
y
Use the
or
key to move between fields. Use the
options.
x
z
or
key to select
Chapter 3 - BIOS Utility 3-17
Advertisement
Table of Contents
