Host Adapter Scsi Termination Selection For Aic-7880 - Acer Altos 900 User Manual

Adaptec AIC7880 Ultra/Ultra W
Configuration
SCSI Bus Interface Definitions
Host Adapter SCSI ID ...................................7
SCSI Parity Checking....................................Enabled
Host Adapter SCSI Termination ....................Low OFF/High ON
Additional Options
Boot Device Options......................................Press <Enter>
SCSI Device Configuration............................Press <Enter>
Advanced Configuration Options...................Press <Enter>
Arrow keys to move cursor, <Enter> to select option, <Esc> to exit (
Figure 4-5 Host Adapter SCSI Termination Selection for AIC-7880
Use the cursor ( ↑ ↓ ) and Enter keys to make your selection.
Since the system contains both wide (68-pin)
SCSI devices and narrow (50-pin) SCSI devices,
termination must be set to allow each section of
the SCSI bus to be terminated. The narrow
device in this system is terminated, causing the
LOW byte on the motherboard to be turned off.
On the other end, the back panel terminates both
bytes (Low OFF/High ON).
Boot Device Options
This option shows the target ID of the device you are booting from. The default
setting is 0 (zero). We recommend that you not change this setting. Some
operating systems will not run unless the boot device is set at zero.
Figure 4-6 shows the Boot Device Options screen.
SCSISelect (TM)
AIC-7880 Ultra/Ultra W at Bus:Device 00:10h
* Low ON/High ON
Low OFF/High OFF
Low OFF/High ON
<F6> - Reset to Host Adapter Defaults
Chapter 4 - SCSISelect Configuration Utility 4-9
Utility v1.2
* =default)