Workplace Inspection - Genie DPL Super Series Operator's Manual

First Edition • Fifth Printing
Do Not Operate Unless:
You learn and practice the principles of safe
machine operation contained in this operator's
manual.
1 Avoid hazardous situations.
2 Always perform a pre-operation
inspection.
3 Always perform function tests prior to use.
4 Inspect the workplace.
Know and understand the workplace
inspection before going on to the next
section.
5 Only use the machine as it was intended.
Fundamentals
The Workplace Inspection helps the operator
determine if the workplace is suitable for safe
machine operation. It should be performed by the
operator prior to moving the machine to the
workplace.
It is the operator's responsibility to read and
remember the workplace hazards, then watch for
and avoid them while moving, setting up and
operating the machine.
Part No. 38132

Workplace Inspection

Workplace Inspection
Be aware of and avoid the following hazardous
situations:
· drop-offs or holes
· bumps, floor obstructions or debris
· overhead obstructions and high voltage
conductors
· hazardous locations
· inadequate surface support to withstand all load
forces imposed by the machine
· wind and weather conditions
· the presence of unauthorized personnel
· other possible unsafe conditions
Genie DPL Super Series
Operator's Manual
17