Genie DPL Super Series Operator's Manual page 12

Operator's Manual
PRE-OPERATION INSPECTION
Pre-operation Inspection
o Be sure that the operator's, safety and
responsibilities manuals are complete, legible
and in the storage container located in the
platform.
o Be sure that all decals are legible and in place.
See Decals section.
o Check for battery fluid leaks and proper fluid
level. Add distilled water if needed. See
Maintenance section.
o AC & DC models: Check for hydraulic oil leaks
and proper oil level. Add oil if needed. See
Maintenance section.
o Air models: Check the oil level of the air line
lubricator. Add oil as needed. See Maintenance
section.
o Air models: Check the oil lubricator Canister drip
rate. Adjust as needed. See Maintenance
section.
o Air models: Check the air filter/regulator
canister. Drain water as needed. See
Maintenance section.
Check the following components or areas for
damage and improperly installed, loose or missing
parts:
o Electrical components and wiring
o Coil cord (if equipped)
o AC & DC models: Hydraulic power unit,
hoses, fittings and cylinders
o Air models: Air power unit, air lines, hoses,
fittings and cylinders
o Manual lowering lever
o Platform end guard rail, platform side guard
rails and platform entry gate
10
o Guard rail lock handles
o Sequencing cables and pulleys
o Lifting chains and idler wheels
o Nuts, bolts and other fasteners
o Mast and mast braces
o Breather cap
o Outriggers, leveling jacks and footpads
o Guard rail lift arm
o Platform entry ladder
Check entire machine for:
o Dents or damage
o Corrosion or oxidation
o Crack in welds or structural components
o Inspect and clean battery terminals and all
battery cable connections.
o Be sure that all structural and other critical
components are present and all associated
fasteners and pins are in place and properly
tightened.
Genie DPL Super Series
First Edition • Fifth Printing
Part No. 38132