Genie DPL Super Series Operator's Manual page 6

Operator's Manual
SAFETY RULES
Electrocution Hazards
becomes electrically charged. Personnel on the
ground or in the platform must not touch or operate
the machine until the energized power lines are
shut off.
Maintain safe distances from electrical power lines
and apparatus in accordance with applicable
governmental regulations and the following chart.
Voltage
Phase to Phase
0 to 300V
300V to 50KV
50KV to 200KV
200KV to 350KV
350KV to 500KV
500KV to 750KV
750KV to 1000KV
4
This machine is not
electrically insulated and
will not provide protection
from contact with or
proximity to electrical
current.
Keep away from the
machine if it contacts
energized power lines or
Minimum Safe
Approach Distance
Feet Meters
Avoid Contact
10 3.05
15 4.60
20 6.10
25 7.62
35 10.67
45 13.72
Genie DPL Super Series
Allow for platform movement, electrical line sway
or sag and movement due to strong or gusty winds.
Do not use the machine as a ground for welding.
Do not operate an AC powered machine or a DC
battery charger unless using a 3-wire grounded
extension cord connected to a grounded AC circuit.
Do not alter or disable the 3-wire grounded plugs.
Collision Hazards
Check the work area for overhead obstructions or
other possible hazards.
Be aware of crushing hazard when grasping the
platform side guard rails.
Do not lower the platform unless the area below is
clear of personnel and obstructions.
Be careful when transporting on an incline.
Stay clear of descending platform.
Component Damage Hazards
Do not operate the machine unless a breather cap
has been installed in the hydraulic reservoir. See
Pre-operation Inspection section for breather cap
instructions.
Do not use the machine as an electrical ground for
welding.
DC models: Do not operate the machine with a
weak or overly discharged battery.
First Edition • Fifth Printing
Part No. 38132