Genie DPL Super Series Operator's Manual page 4

Operator's Manual
SAFETY RULES
Tip-over Hazards
Do not adjust or remove the outriggers while the
platform is occupied or raised.
Do not place or attach overhanging loads to any
part of this machine.
Do not place ladders or scaffolds in the platform or
against any part of this machine.
Do not push off or pull toward any object outside
the platform.
Do not use the machine to lift material or
equipment. The machine is intended to lift
personnel and tools to an aerial work site.
2
Do not raise the platform
unless the base is level,
all four outriggers are
properly set up and the
leveling jacks firmly
contact the ground.
Do not move the machine
while the platform is
raised.
Do not raise the platform
unless the machine is
level. Do not set the
machine up on a surface
where it cannot be leveled
using only the leveling
jacks. Do not use chocks,
blocks or shims of any
kind to level the machine.
Genie DPL Super Series
Do not use the machine on a moving or mobile
surface or vehicle.
Do not operate the machine in strong or gusty
winds. Do not increase the surface area of the
platform or the load. Increasing the area exposed to
the wind will decrease machine stability.
Do not exceed the rated platform load capacity.
Maximum capacity - DPL-25S
ANSI
CSA
Maximum occupants - ANSI and CSA
CE
Maximum occupants - CE
Outdoor use
Indoor use only
Maximum capacity - DPL-30S
ANSI
CSA
Maximum occupants - ANSI and CSA
CE
Maximum occupants - CE
Outdoor use
Indoor use only
First Edition • Fifth Printing
750 lbs 340 kg
600 lbs 272 kg
750 lbs 340 kg
750 lbs 340 kg
600 lbs 272 kg
750 lbs 340 kg
Part No. 38132
2
1
2
2
1
2