Table of Contents
Advertisement
Fitting the thermal insulation
Aligning the retaining rails and fitting the front panel
4.
3.
Fig. 8
Cleaning gate
A
1. If necessary, align the retaining rails on the r.h. and
l.h. side of the boiler and tighten the screws.
2. Secure the location studs to the front retaining
rails.
3. Insert the thermal insulation mat into the front
panel.
Fitting the display panel and sensors
!
Please note
Damaged capillary tubes will result in faulty sen-
sor function.
Never kink the capillary tubes.
(cont.)
0
A
2.
1.
8x
4. Position the front panel on the location studs and
press together firmly, first at the bottom, then at the
top.
Note
For easier handling, first place the front panel on
cleaning gate
.
A
Note
The ribbon cable of the programming unit must not be
kinked.
Installation sequence
15
Advertisement
Table of Contents
