Sony Giga Juke NAS-S55HDE Operating Instructions Manual page 109

1
Connect the sender system to the
receiver system with an optional
LAN cable (cross cable).
LAN cable (cross)
Note
Although an ordinary LAN cable (straight cable)
is used to connect the unit to the network, this
type cannot be used for this operation. Be careful
to distinguish between the two types of cables
(straight cable and cross cable) since both are
similar in appearance.
2
In the sender system, enter the
Settings menu and select [Move
track data].
3
Read the contents in [Read me],
and then select [Next].
4
Select the direction for the track
data from the [Moving direction]
pull-down menu, and then select
[Check].
5
Repeat steps 2 to 4 in the receiver
system.
If all of the data cannot be moved for some
reason (for example, because of insufficient
HDD space or limits on the number of
folders in the receiver system), a message
will appear. To cancel moving, select [Close],
and then select [Stop] in step 6. The unit
automatically restarts after cancelling.
6
When the data moving display
appears, select [Start].
7
Select [Yes].
The moving starts.
When the moving has completed, the unit
automatically restarts, and then turns off.
10
GB