Transparency Interleaving; Transparency Printing - Canon IMAGERUNNER C2550 Printer Manual

Transparency Interleaving

3

Transparency Printing

3-38
Settings Menu
NOTE
This function is only available if 'Booklet' is set to [On].
•
Pressing [ ] increase the setting value by 0.001" (0.05 mm) each time the key is
•
pressed. Pressing [
time. Holding down either [
alteration.
If this setting is used in combination with the 'Offset Short Edge/Offset Long Edge'
•
or 'Margin', the values of these three settings are added together.
Off * , Blank, and Printed
If you are printing on transparencies, you can use this setting to output a sheet of
paper after each transparency. The paper can be blank, or it can be a paper copy
of the transparency.
If [Off] is selected, no sheets are interleaved with the transparencies.
If [Blank] is selected, a blank sheet of paper is inserted between each
transparency.
If [Printed] is selected, a printed paper from the print job is inserted between each
transparency.
When [Blank] or [Printed] is selected, you can set Transparency Interleaving to
print multiple copies in the number specified in [Copies] settings.
IMPORTANT
[Collate] is the only 'Finishing' setting that you can specify to use in combination
with 'Transparency Interleaving'.
NOTE
If [Printed] is selected, the paper printouts are included in the Prints count.
However, if [Blank] is selected, they are not included in the Prints count.
Transmissive * , Reflective
Transparencies are printed according to the method suited to the type of the
selected OHP (Over Head Projector) device.
NOTE
This setting does not affect the printing of sheets of paper for insertion between
•
transparencies.
When printing on OHP film, the setting for 'Toner Save' is invalid. However, it does
•
not affect the printout of sheets of paper for insertion between transparencies.
] decreases the setting value by 0.001" (0.05 mm) each
] or [ ] continuously speeds up the value