Canon IMAGERUNNER C2550 Printer Manual page 232

You cannot print the last page.
Cause
Remedy
A print job that you have specified as two-sided printing is printed on one side of the paper.
Cause 1
Remedy
Cause 2
Remedy
The data does not fit on the page properly.
6
Cause 1
Remedy
Cause 2
Remedy 1 Insert margins around the data and print the data again. (See the Help function
Remedy 2 Change the 'Scaling' settings on the printer driver and print the data again. (See
The printing location has slipped.
Cause 1
Remedy
Cause 2
Remedy
6-16
Printing Problems
The command that identifies the end of the data has not been sent from the PC.
(The Processing/Data indicator is blinking or lit.)
Clear the print data. (If you print from application software that does not have a
print function and the last page of data is not a full page, the data will remain in
the machine's memory.) (See Chapter 2, "Handling Different Print Jobs.")
The paper size you have specified is not supported by two-sided printing.
Change the print job settings and print the data again.
The settings for the front and back sides of the paper are different.
Change the print job settings and print the data again.
The paper is not in the correct position.
Make sure the machine is set correctly and try printing again. (See Chapter 7,
"Routine Maintenance," in the Reference Guide.)
The data is outside the printable area.
on the printer driver or the application software manual.)
Chapter 3, "Basic Print Options," in the PCL Driver Guide, the PS Driver Guide,
or the UFR II Driver Guide.)
Margin, Offset Short Edge, or Offset Long Edge in the printer settings menu
have been changed.
Set Margin, Offset Short Edge, and Offset Long Edge to '0.00' and print the data
again. (See "Margin," on p. 3-22, "Offset Short Edge/Offset Long Edge (Front),"
on p. 3-24, and "Offset Short Edge/Offset Long Edge (Back)," on p. 3-25.)
The application software's top margin and paper location settings are not
correct.
Set the correct settings for the top margin and the paper location and print the
data again. (See the application software manual.)