Margin - Canon IMAGERUNNER C2550 Printer Manual

■ Margin

3
3-22
Settings Menu
-1.90 to +1.90 inches (in increments of 0.01 inches); 0.00
This setting enables you to set the page margin. The settings can be set in
increments of 0.01" (0.5 mm) from -1.90" (-50.0 mm) through +1.90" (+50.0 mm).
Use [ ] to increase the width of the inside margin.
Use [ ] to increase the width of the outside margin.
[0 inches]
Center
You can specify the edge along which the margin will be created in the 'Binding
Location' setting (previous setting). To create a margin along one of the edges of
the paper, use this setting in combination with the 'Binding Location' setting.
IMPORTANT
If this setting moves the image outside the printable area, part of the image may be
cut off.
NOTE
If this setting is used in combination with 'Offset Short Edge/Offset Long Edge', the
•
values of the two settings are added together.
Pressing [ ] increases the setting value by 0.01" (0.5 mm) each time the key is
•
pressed. Pressing [
down either [ ] or [
[ + ] [ - ]
Center Center
] decreases the value by 0.01" (0.5 mm) each time. Holding
] continuously speeds up the value alteration.
inches
*