Panasonic PT-FRQ50 Operating Instructions Manual page 27

Top
Projection direction
1 Remote control signal receiver (front)
2 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
3 Light source indicator <LIGHT>
Indicates the status of the light source.
4 Temperature indicator <TEMP>
Indicates the internal temperature status.
5 Projection lens
6 Lens shift lever
Adjusts the projection position.
7 Adjustable feet
Adjusts the projection angle.
8 Intake vent
9 Exhaust vent
10 Remote control signal receiver (rear)
Attention
f Do not block the intake and exhaust vents of the projector.
r Control panel
1 Power < v / b > button
( v : Standby, b : Power on)
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
Sets the projector to projection mode when the power is switched
off (standby mode).
Chapter 1 Preparation — About your projector
1
2
Bottom
11 Focus ring
Adjusts the focus.
12 Zoom ring
Adjusts the zoom.
13 Control panel ( x page 27)
14 Connecting terminals ( x page 28)
15 Security slot
This security slot is compatible with the Kensington security
cables.
16 <MAIN POWER> switch
Turns on/off the main power.
17 <AC IN> terminal
Connect the supplied power cord.
18 Burglar hook port
Attaches a burglar prevention cable, etc.
3
2 <MENU> button/<RETURN> button/<ENTER> button/ asqw
buttons
Used to navigate through the menu screen.
Also used to enter a password in the [SECURITY] menu or enter
characters.
3 <INPUT SELECT> button
Switches the input signal to project. ( x page 51)
8 18
ENGLISH - 27