[Function Button] - Panasonic PT-FRQ50 Operating Instructions Manual

4) Press qw to switch the item.
[PROJECTOR]
[DIGITAL LINK]
5) Press as to select [BAUDRATE].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[9600]
[19200]
[38400]
7) Press as to select [PARITY].
8) Press qw to switch the item.
f The items will switch each time you press the button.
[NONE]
[EVEN]
[ODD]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK/
LAN> terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f The input communication speed is fixed to 9 600 bps when [INPUT SELECT] is set to [DIGITAL LINK].

[FUNCTION BUTTON]

Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
[OSD POSITION]
4) Press the <ENTER> button.
Note
f The [FUNCTION BUTTON] screen can also be displayed by holding down the <FUNCTION> button on the remote control.
118 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Performs the RS-232C communication with the <SERIAL IN> terminal of the projector.
Performs the RS-232C communication via the optional DIGITAL LINK output supported device (Model
No.: ET-YFB100G, ET-YFB200G) and the <DIGITAL LINK/LAN> terminal.
Select the proper speed.
Select the parity condition.
Disables the <FUNCTION> button.
Displays the sub memory list. ( x page 131)
Switches the [SYSTEM SELECTOR] setting. ( x page 72)
Switches the [DAYLIGHT VIEW] setting. ( x page 70)
Temporarily pauses the image. ( x page 100)
Displays the waveform of the input signal. ( x page 101)
Switches the aspect ratio of the image. ( x page 74)
Switches the [PROJECTION METHOD] setting. ( x page 103)
Switches the [GEOMETRY] setting. ( x page 76)
Switches the [OSD POSITION] setting. ( x page 97)