Panasonic PT-FRQ50 Operating Instructions Manual page 122

r [CONTENT INFORMATION]
[EOTF]
[MASTERING DISPLAY
COLOR VOLUME]
[CONTENT LIGHT LEVEL]
Note
f If you press the <ENTER> button while displaying [SIGNAL INFORMATION] in the page 4/4 of the [STATUS] screen, the [DETAILED
INFORMATION] screen can be displayed to view the detailed information of the input signal. Information for multiple input signals may be
displayed depending on the projected image. Press qw to switch pages.
f While the [DETAILED INFORMATION] screen is displayed, press the <ENTER> button to display the [CONTENT INFORMATION] screen,
and the contents of the InfoFrame information added to the input signal can be displayed.
f There are items that are displayed or not displayed in [SIGNAL INFORMATION], [DETAILED INFORMATION], and [CONTENT
INFORMATION] depending on the setting and the signal being input.
f If any abnormality has occurred on the projector, press the <DEFAULT> button while the [STATUS] screen is displayed to check the details
of the error information.
f For details on the contents displayed in [SELF TEST], refer to "Self-diagnosis display" ( x page 196).
Sending status content via E-mail
The status content can be sent to the E-mail address (up to two addresses) set in "[E-mail set up] page"
( x page 172).
1) Press the <ENTER> button while the 1/4 to 3/4 page of the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [SEND E-MAIL].
3) Press the <ENTER> button.
f The [SELECT E-MAIL ADDRESS] screen is displayed.
4) Press as to select the destination.
5) Press the <ENTER> button.
f The confirmation screen is displayed.
6) Press qw to select [OK], and press the <ENTER> button.
f The status content is sent.
Saving status content in USB memory
The status content can be saved in a USB memory attached to the <USB (DC OUT)> terminal.
1) Press the <ENTER> button while the 1/4 to 3/4 page of the [STATUS] screen is displayed.
f The selection screen is displayed.
2) Press as to select [SAVE TO USB MEMORY].
3) Press the <ENTER> button.
f The confirmation screen is displayed.
4) Press qw to select [OK], and press the <ENTER> button.
f The status content is saved.
122 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays EOTF (Electro-Optical Transfer Function) out of the InfoFrame information added to the input
signal.
Displays the chromaticity coordinates for the primary color red out of the
[RED]
InfoFrame information added to the input signal.
Displays the chromaticity coordinates for the primary color green out of the
[GREEN]
InfoFrame information added to the input signal.
Displays the chromaticity coordinates for the primary color blue out of the
[BLUE]
InfoFrame information added to the input signal.
Displays the chromaticity coordinates for the white point out of the InfoFrame
[WHITE]
information added to the input signal.
Displays the maximum brightness out of the InfoFrame information added to the
[MAX LUMINANCE]
input signal.
Displays the minimum brightness out of the InfoFrame information added to the
[MIN LUMINANCE]
input signal.
Displays MaxCLL (Maximum Content Light Level) out of the InfoFrame
[MaxCLL]
information added to the input signal.
Displays MaxFALL (Maximum Frame Average Light Level) out of the InfoFrame
[MaxFALL]
information added to the input signal.