Panasonic PT-FRQ50 Operating Instructions Manual page 117

9) Press the <ENTER> button.
f The [COMMAND] detailed screen is displayed.
10) Press as to select a [COMMAND].
f For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time
you press qw .
f When [INPUT] is selected, press the <ENTER> button, and then press asqw to select the input to be
set.
[COMMAND]
[POWER ON]
[STANDBY]
[QUICK STARTUP]
[SHUTTER]
[INPUT]
[OPERATING MODE]
[IN STANDBY
MODE(AUDIO)]
[VOLUME]
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
f After the command is fixed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. ( x page 115)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.
[RS-232C]
Set the communication condition of the <SERIAL IN> terminal. Refer to "<SERIAL IN> terminal" ( x page 205).
1) Press as to select [RS-232C].
2) Press the <ENTER> button.
f The [RS-232C] screen is displayed.
3) Press as to select [INPUT SELECT].
Chapter 4 Settings — [PROJECTOR SETUP] menu
Detailed settings of
[COMMAND]
―
―
[ON]
[OFF]
[OPEN]
[CLOSE]
[COMPUTER]
[HDMI1]
[HDMI2]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
[NORMAL]
[ECO]
[QUIET]
[USER]
[OFF]
[ON]
[0] - [63]
Switches on the projector.
Enters standby.
Enables the function of the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [QUICK STARTUP].
Disables the function of the [PROJECTOR SETUP] menu → [ECO
MANAGEMENT] → [QUICK STARTUP].
Disables the shutter function (shutter: open).
Enables the shutter function (shutter: closed).
Switches the input to COMPUTER.
Switches the input to HDMI1.
Switches the input to HDMI2.
Switches the input to DIGITAL LINK.
Switches the input to DIGITAL LINK, and switches the input of the
*1
Panasonic twisted-pair-cable transmitter to the specified input.
Prioritizes luminance.
Controls the power to increase the life of the light source although
the luminance is lower than that of [NORMAL].
Prioritizes the operation with less noise although the luminance is
lower than that of [NORMAL].
Controls the power with the setting set in [USER].
Stops the audio output during standby.
Outputs the audio during standby.
Sets the volume.
Description
ENGLISH - 117