Panasonic PT-FRQ50 Operating Instructions Manual page 179

7) Press the <ENTER> button.
f The [LAN DATA CLONING] screen is displayed.
8) Press as to select [SELECT PROJECTOR].
9) Press the <ENTER> button.
f The projectors in the same subnet are displayed as a list.
10) Press as to select the copy destination projector.
11) Press the <ENTER> button.
f To select multiple projectors, repeat Steps 10) to 11).
12) Press the <DEFAULT> button on the remote control.
f The confirmation screen is displayed.
13) Press qw to select [OK], and press the <ENTER> button.
f Copy of the data between the projectors is started.
Once the copy is completed, results are displayed as a list in the [LAN DATA CLONING] screen.
Meanings of the marks displayed in the list are as follows.
g Green: Data copy has succeeded.
g Red: Data copy has failed. Confirm the connection of the LAN cable and power status of the copy
destination projector.
f Data is copied to the copy destination projector in the standby mode.
If the copy destination projector is in the projection mode, the LAN data cloning request message is
displayed, and then the copy destination projector automatically shifts to the standby mode to start copy of
data.
14) Turn on the copy destination projector.
f The copied content is reflected to the projector.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The light source indicator <LIGHT> and the temperature indicator <TEMP> of the copy destination projector blink while copying the data.
Confirm that the blinking of the indicators stops, and then turn on the projector.
Setting [WRITE PROTECT]
Set if the copy of data via LAN is permitted or not.
1) Press as to select [DATA CLONING] on the copy destination projector.
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
4) Press as to select [LAN].
5) Press the <ENTER> button.
f The [LAN DATA CLONING] screen is displayed.
6) Press as to select [WRITE PROTECT].
7) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Chapter 5 Operations — Using the data cloning function
Permits operations of [DATA CLONING] from another projector via LAN.
Does not permit the operations of [DATA CLONING] from another projector via LAN.
f Data copy will not be possible when [ON] is set. When it is not necessary to copy data, set [ON] so
that the data is not changed by mistake.
ENGLISH - 179