Table of Contents
Advertisement
1. Oil filler cap
2. Dipstick
TIP
The engine oil should be between the "H" and
"L" level marks on the dipstick.
1. "H" level mark
2. "L" level mark
6.
If the engine oil is below the "L" level
mark, add sufficient oil of the recom-
mended type to raise it to the "H" level
mark. (See page 89 for the recommend-
ed oil.) NOTICE: When adding the en-
gine oil, be careful not to fill above the
"H" level mark on the dipstick. Use
only the recommended oil. (See page
89.) Make sure that no foreign material
enters the engine oil tank.
7.
Insert the dipstick into the oil filler hole,
and then tighten the oil filler cap.
8.
Connect the oil level gauge coupler.
Periodic maintenance and adjustment
[ECS00463]
9.
Install the right side cover and the
shroud.
To change the engine oil (with or with-
out oil filter cartridge replacement)
1.
Place the snowmobile on a level surface
and apply the parking brake.
2.
Start the engine, warm it up for several
minutes, and then turn it off.
3.
Remove the shroud, the right side cover,
and the top cover (See page 50 for re-
moval procedures).
4.
Remove the screws and the bolts, and
then pull the right lower cover outward to
remove it.
3
1
1. Screw
2. Bolt
3. Right lower cover
5.
Remove the bottom panel by removing
the bolts.
1. Bolt
2. Bottom panel
2
2
1
1
59
Advertisement
Table of Contents
