Table of Contents
Advertisement
TIP
An oil filter wrench is available at a Yamaha
dealer.
12. Apply a thin coat of engine oil to the O-
ring of the new oil filter cartridge.
1. O-ring
TIP
Make sure that the O-ring is properly seated.
13. Install the new oil filter cartridge with an
oil filter wrench, and then tighten it to the
specified torque.
Tightening torque:
Oil filter cartridge:
17 Nm (1.7 m·kgf, 12 ft·lbf)
14. Install the engine oil drain bolts and their
new gasket, and then tighten the bolts to
the specified torques.
Tightening torques:
Engine oil drain bolt (crankcase):
10 Nm (1.0 m·kgf, 7.2 ft·lbf)
Engine oil drain bolt (oil tank):
16 Nm (1.6 m·kgf, 12 ft·lbf)
15. Add 2.0 L (2.11 US qt, 1.76 Imp.qt) of the
recommended engine oil to the oil tank,
and then install and tighten the oil filler
cap and the cylinder head cap.
Periodic maintenance and adjustment
Recommended engine oil:
See page 89.
16. Start the engine, warm it up for several
minutes, and then turn it off.
17. Remove the oil filler cap, and then add
sufficient oil of the recommended type to
raise it to the "H" level mark on the dip-
stick. NOTICE: When adding the en-
gine oil, be careful not to fill above the
"H" level mark on the dipstick. Use
only the recommended oil. (See page
89.) Make sure that no foreign material
enters the engine oil tank.
1. "H" level mark
2. "L" level mark
Recommended engine oil:
See page 89.
Oil quantity:
With oil filter cartridge replacement:
3.3 L (3.49 US qt, 2.90 Imp.qt)
Without oil filter cartridge replace-
ment:
3.1 L (3.28 US qt, 2.73 Imp.qt)
Total amount:
4.0 L (4.23 US qt, 3.52 Imp.qt)
18. Install and tighten the oil filler cap.
19. Start the engine, and then let it idle for
several minutes while checking it for oil
leakage. If oil is leaking, immediately turn
the engine off and make sure that the en-
[ECS00463]
1
2
61
Advertisement
Table of Contents
