Table of Contents
Advertisement
Control functions
To increase the compression damping force,
turn the adjusting knob in direction (a). To de-
crease the compression damping force, turn
the adjusting knob in direction (b). NOTICE:
Do not continue to turn the adjusting knob
in direction (a) after it stops. The shock ab-
sorber could be damaged and damping
force adjustments will not be able to be
made. Do not turn the adjusting knob in di-
rection (b) more than 12 click(s). Even if
the adjusting knob is continually turned af-
ter 12 click(s), there will be no change in
the damping force. Be sure to stop the ad-
justing knob at a position where there is a
click.
[ECS00911]
1. Compression damping force adjusting
knob
Compression damping force setting:
Minimum (soft):
12 click(s) in direction (b)*
Standard:
6 click(s) in direction (b)*
Maximum (hard):
2 click(s) in direction (b)*
* With the adjusting knob fully turned in
direction (a)
32
(a)
(b)
1
ESU11036
Adjusting the control rods
EWS00771
WARNING
The left and right adjusting nuts must be
set to the same position. Uneven settings
can cause poor handling and loss of sta-
bility.
The weight transfer can be adjusted by turn-
ing the adjusting nuts on the control rods.
1.
Loosen the locknut while holding the ad-
justing nut.
(b)
(a)
1. Locknut
2. Control rod adjusting nut
2.
To increase weight transfer, turn the ad-
justing nut in direction (a), and to de-
crease weight transfer, turn it in direction
(b). WARNING! Never adjust the con-
trol rods beyond the maximum set-
1
2
Advertisement
Table of Contents
