Table of Contents
Advertisement
2.
Push the "RESET" button for at least 1
second while the oil change tripmeter
and "OIL" are flashing alternately in the
odometer display. The distance traveled
since the last oil change and "OIL" will
flash alternately in the odometer display.
3.
Push the "RESET" button for approxi-
mately 3 seconds. "00000" and "OIL" will
flash alternately in the odometer display
3 times, and then the display will return
to the previous display mode.
If the engine oil is changed before the oil
change tripmeter appears in the display (i.e.,
before the periodic oil change interval has
been reached), the tripmeter must be reset
after the oil change for the next periodic oil
change to be indicated at the correct time.
In that case, reset the oil change tripmeter as
follows.
To reset the oil change tripmeter (when the
engine oil was changed before the oil change
tripmeter appeared)
1.
Push the "SELECT" button until "ODO"
is displayed, and then push the "RESET"
button for at least 1 second. The dis-
tance traveled since the last oil change
and "OIL" will flash alternately in the
odometer display.
2.
Push the "RESET" button for approxi-
mately 3 seconds. "00000" and "OIL" will
flash alternately in the odometer display
3 times, and then the display will return
to the previous display mode.
Control functions
Clock
F
E
1. Clock
To set the clock
1.
Turn the key to the on position.
2.
Push the "SELECT" button and "RESET"
button simultaneously until the hour dig-
its start flashing.
3.
Push the "RESET" button to change the
hour setting, and then push the "SE-
LECT" button. The minute digits will start
flashing.
4.
Push the "RESET" button to change the
minute setting, and then push the "SE-
LECT" button. The clock starts when the
"SELECT" button is released.
TIP
The clock must be set again when the battery
is disconnected.
Display brightness control
This function allows you to adjust the bright-
ness of the meter unit display to suit the out-
door lighting conditions.
1
15
Advertisement
Table of Contents
