Table of Contents
Advertisement
ting, indicated by red paint; otherwise,
they could be damaged, which could
lead to an accident or injury.
RST90PGT
1
5
4
1. Locknut
2. Control rod adjusting nut
3. Standard position
4. Adjustable range
5. Red paint area
RST90PTF
1
5
4
1. Locknut
2. Control rod adjusting nut
3. Standard position
4. Adjustable range
5. Red paint area
3.
Tighten the locknut while holding the ad-
justing nut in place. NOTICE: Always
tighten the locknut against the adjust-
ing nut, and then tighten the locknut to
the specified torque.
Locknut tightening torque:
25 Nm (2.5 m·kgf, 18 ft·lbf)
[EWS00174]
2
3
2
3
[ECS00861]
Control functions
ESU13114
Adjusting the spring preload of the
sliding frame extension (RST90PTF)
EWS00751
WARNING
The left and right spring preloads must be
adjusted to the same setting. Uneven set-
tings can cause poor handling and loss of
stability.
The spring preload of the sliding frame exten-
sion can be adjusted by turning the adjusting
nuts.
To increase the spring preload, turn the ad-
justing nut in direction (a). To decrease the
spring preload, turn the adjusting nut in direc-
tion (b).
(a)
(b)
1. Spring preload adjusting nut
2. Distance A
TIP
The spring preload setting is determined by
measuring distance A, shown in the illustra-
tion. The longer distance A is, the higher the
spring preload; the shorter distance A is, the
lower the spring preload.
1
2
33
Advertisement
Table of Contents
