Automatic Dialing - Canon MultiPASS C3500 User Manual

Automatic Dialing

You can send a document using one-touch speed dialing, coded speed
dialing, or group dialing. You must register the one-touch speed dialing
numbers, the coded speed-dialing numbers, and the group dialing
numbers using the MultiPASS Desktop Manager before you can send
documents using these automatic dialing methods. See Setting Up Speed
Dial Assignments on page 8-12.
Load the
document.
4-4 Sending Faxes With the MultiPASS C3500
When the document has been sent successfully, the
display shows these messages.
The MultiPASS automatically redials if the receiving fax does
not answer, if the line is busy, or if a transmission error
occurs. You can specify the number of times it redials using
the Retries option in the Send Fax dialog box of the
MultiPASS Desktop Manager (see page 8-4). If all redial
attempts fail, the MultiPASS beeps intermittently for a few
seconds. If this happens, check the fax number and try
sending the fax again.
If the light is flashing, correct the error described in
ALARM
the LCD display, and then press
the operator panel to remove the document from the ADF
(see page 10-3).
Place the document face down in the ADF.
DOCUMENT READY
TRANSMITTING OK
TX/RX NO. 0001
. You may need to open
STOP
Chapter 4