Canon MultiPASS C3500 User Manual page 268

Message
DIALING
DOC TOO LONG
DOCUMENT READY
ECM RX
ECM TX
HANG UP PHONE
INSTALL BC-20/21
INSTALL BC-21
LOAD PAPER
10-8 Troubleshooting
Error Code Cause
— The MultiPASS is
dialing the receiving
fax machine.
#003 It took more than 32
minutes to send or
copy a document.
It took more than 32
minutes to receive a
document.
The document is longer
than 39.4 inches (1 m).
— The document in the
ADF is ready for faxing,
scanning, or copying.
— The MultiPASS is
receiving a fax
using ECM.
— The MultiPASS is
sending a fax using
ECM.
— The telephone is
off hook.
— The BC-22e or BC-29F
BJ Cartridge is installed,
so the MultiPASS cannot and install the BC-21e
print any received faxes,
or make copies.
— The BC-20, BC-22e,
or BC-29F BJ Cartridge
is installed.
— The MultiPASS is out
of paper (the sheet
feeder is empty).
Action
Press if you
STOP
want to cancel the
transmission.
Divide the document
and send or copy each
part separately.
Contact the other party.
Have them divide the
document and send
each part separately.
Use a copy machine to
make a reduced copy of
the document and send
the copy.
Send the fax, scan the
document, or make the
copy.
ECM transmissions may
take longer than normal
transmissions. Turn
off ECM if you need to
receive quickly, or if you
know your local lines
are in good condition.
ECM transmissions may
take longer than normal
transmissions. Turn off
ECM if you need to
transmit quickly, or if
you know your local
lines are in good
condition.
Place the telephone
properly into its cradle.
Remove the BC-22e or
BC-29F BJ Cartridge
or BC-20 BJ Cartridge.
Remove the BC-20,
BC-22e, or BC-29F
BJ Cartridge and install
the BC-21e BJ Cartridge.
Load paper in the sheet
feeder. Make sure the
stack does not exceed
the limit mark. Then
press
.
START/COPY
Chapter 10