Adjusting The Quality Of Your Faxes; Setting The Resolution - Canon MultiPASS C3500 User Manual

N
If the memory becomes full while scanning your document, the LCD
displays
MEMORY FULL
to remove the document; see page 10-3.) You can split the document
into two or three different jobs, or you can try sending the document to
one location at a time.

Adjusting the Quality of Your Faxes

Canon's Ultra High Quality (UHQ™) imaging technology enables you
to send faxes that have a print quality very close to that of the original
document. The MultiPASS also allows you to adjust the resolution and
contrast it uses in sending faxes to best suit your particular document.

Setting the Resolution

Resolution is a measure of the fineness or clarity of a printout and is
usually expressed in horizontal and vertical dots per inch (dpi). Low
resolutions may cause text and graphics to have a jagged appearance,
while higher resolutions provide smoother curves and lines, crisp text
and graphics, and a better match to traditional typeface designs.
Chapter 4
The MultiPASS begins the operation approximately ten
seconds after you press the last button (five seconds if you
press only one button) even if you do not press
.
START/COPY
The MultiPASS dials the destinations in numerical order
starting with the coded dial numbers, then the one-touch
numbers, and finally the regular-dial number (regardless of
the order in which you entered the numbers).
To cancel a transmission, press
or transmission. All subsequent transmissions in the
sequence are cancelled. (You may need to open the
operator panel to remove the document; see page 10-3.)
. (You may need to open the operator panel
Sending Faxes With the MultiPASS C3500
during the dialing
STOP
4-13