Omron FH Series Hardware Setup Manual page 74

3 Configuration
Component Names and Functions
 Front View
 Rear
(5) MENU button
(6) + button
(7) - button
(8) AUTO button
(1) LED indicator lamp (for
power)
(2) LED indicator lamp (for
SYNC)
(3) Power supply terminal
(4) Video input (RGB)
(5) MENU button
(6) + button
(7) - button
(8) AUTO button
(9) VESA mounting hole (M4)
Wire
The power terminal block for the Touch Panel Monitor is located on the back of it.
Connect a power supply of 24 VDC there.
24 VDC
Power
supply
24 VDC
• Keep the power supply wires as short as possible (maximum 10 m).
3-26
(1) LED indicator lamp (for power)
Display section
(4) Video input (RGB)
(3) Power connection
terminal
Name
Lit up green when power is ON.
Lit up orange while the video signal is input.
Connect a 24 VDC power supply.
Video input terminal (RGB)
OSD operating button (MENU button)
OSD operating button (+ button)
OSD operating button (- button)
OSD operating button (AUTO button)
Mounting hole for VESA 75 mm x 75 mm.
M3
(Outside diameter of crimp terminal:
Dia 5.5 mm maximum)
RGB
Recommended model
OMRON Corporation-manufactured
S8VS-03024
FH Series Vision System Hardware Setup Manual for 3D Robot Vision (Z436-E1)
(2) LED indicator lamp
(for SYNC)
(9) VESA mounting
hole (M4)
Description