Omron FH Series Hardware Setup Manual page 68

3 Configuration
Component Names and Functions
●Front view
(1) LED indicator lamp
●Connection terminal
(8) RS-232C
(9) USB (TypeB)
(1) LED indicator lamp
(2) VESA mounting hole (M4)
(3) VESA mounting hole (M4)
(4) USB retaining bracket
(5) Power supply terminal
(6) Monitor connector (analog
RGB)
(7) OSD Menu button
(8) RS-232C
(9) USB (TypeB)
(10) Touch pen
(11) Touch pen holder
(12) Mounting Brackets
For operation at launch OSD, refer to the Model FH-MT12 INSTRUCTION SHEET.
3-20
●Rear view
(7) OSD Menu button
(6) Monitor connector
(analog RGB)
(10) Touch pen
Name
Lit up green when power is ON.
Lit up orange when video signal is no input.
Unlit when power is OFF.
Mounting hole for VESA 75 mm x 75 mm.
Mounting hole for VESA 100 mm x 100 mm.
Retaining bracket for USB cable.
Connect a 24 VDC power supply.
Connect a monitor cable for analog RGB.
The button to activate the OSD menu.
Connect a serial communication port for touch panel communication.
Connect a USB port (Type B) for touch panel communication.
Use for operation of touch panel.
Put touch pen in it when not using.
Paste it on the monitor by double-sided tape.
Use them to mount the panel.
FH Series Vision System Hardware Setup Manual for 3D Robot Vision (Z436-E1)
(2) VESA mounting hole pitch 75 mm (M4)
(3) VESA mounting hole pitch 100 mm (M4)
(4) USB retaining bracket
(5) Power supply terminal
(12) Mounting Brackets
(11) Touch pen holder
Description