Omron FH Series Hardware Setup Manual page 69

Touch Panel Monitor Cable
Normally, use the USB cable as a connection cable for Touch Panel Monitor.
Use the RS-232C cable as a connection cable for Touch Panel Monitor in the following cases.
• When Touch Panel Monitor is taken apart 5 m or more from FH Sensor Controller.
• When the USB port of the FH Sensor Controller is used for other I/O connection and cannot be used
for Touch Panel communications.
 Specification
Model
Cable type
Vibration (resist-
ance)
Ambient tempera-
ture range
Ambient humidity
range
Ambient atmos-
phere
Material
Minimum bending
radius
Weight
Connection Example
 USB Connection (Cable Length Up to 5 m)
FH-MT12
Analog RGB
FH Series Vision System Hardware Setup Manual for 3D Robot Vision (Z436-E1)
FH-VMDA (2m)
DVI-Analog Conversion
Cable
10 to 150 Hz, Single amplitude 0.1 mm, 10 times for 8 minutes for each three direction
Operating Condition: 0 to +50°C, Storage Condition: -10 to +60°C (with no icing or
condensation)
Operating and Storage: 35 to 85% (with no condensation)
No corrosive gases
Cable outer sheath, Connector: PVC
36 mm
Approx. 220g
Type B
Touch panel cable(USB): FH-VUAB
D-Sub
Monitor cable: FH-VMDA
USB
FH-VUAB (2m)
USB Cable
25 mm
Approx. 75g
Connect a cable to an arbitrary
USB port of the FH controller.
Type A
DVI-A
DVI-I
FH controller
3 Configuration
XW2Z-200PP-1 (2m)
RS-232C Cable
Cable outer sheath: PVC,
Connector: ABS/Ni Plating
59 mm
Approx. 162g
3-21
3