Vdr Connection - Furuno FAR-3220-NXT Installation Manual

2. WIRING
2.11

VDR Connection

You can connect a VDR to this radar in one of two manners: DVI-I (Analog RGB) or
LAN.
2.11.1 DVI-I (Analog RGB) connection
• Use the optional RGB cable (DVI-BNCX5-L2000) to connect the VDR.
• The DVI-D port and DVI-I port each have their own circuits. This prevents the inter-
ruption of the radar picture shown on the main monitor (connected to the DVI-D
port), if a fault occurs at the DVI-I port.
• The processor unit continuously outputs video signals from its DVI-D and DVI-I
ports. These signals cannot be stopped by the operator.
2.11.2 LAN connection
• Connect the VDR to the LAN2 port of the EC-3000.
The VDR must comply with IEC 61160-450 standards.
• To set up the VDR, refer to the Instruction Manual supplied with the VDR, as well
as the Settings and Adjustments Instruction Manual supplied with this radar.
• The image output from the LAN2 port is the same resolution as the image output
from the DVI-D port.
2-54