Furuno FAR-3220-NXT Installation Manual page 54

2. WIRING
RW-9600
Sheath Sheath
8. Pass the antenna cable through the cable clamp.
9. Connect the power line of the antenna cable to the 13-pin WAGO connector, re-
ferring to the interconnection diagram at the back of this manual.
10. Connect the power line and the LAN cable of the antenna cable as shown below.
Connect power line of Connect power line of
antenna cable to TB131 antenna cable to TB131
on PSU-TB Board. on PSU-TB Board.
For retrofit antenna
cable, connect unused
lines here.
11. Connect the shield wires of the antenna cable and serial cable for the processor
unit.
12. Reattach the cable clamp assembly.
2-24
Armor Vinyl tape
30 100
40
Crimp-on lug (M4)
Insert the antenna cable. Insert the antenna cable.
Grounding point (for antenna cable) Grounding point (for antenna cable)
Grounding point Grounding point
(for serial cable for processor unit) (for serial cable for processor unit)
170
6
180
14
Connect LAN cable of
antenna cable to J102
on PSU-CNTL Board.
Ground the LAN
cable.
Clamp the armor.
Power line
Coaxial cable
9
5