Furuno FAR-3220-NXT Installation Manual page 89

5. Use the scrollwheel to set [START]
and [ANGLE], referring to the example
below. Spin the scrollwheel to set and
push it to confirm.
A solid green line marks the dual radar
display area.
• [START]: Start point of the sector (in
degrees, 000-359).
• [ANGLE]: Horizontal width of the
sector (in degrees, 000-359).
6. Select [3 COMBINE RANGE] to set the vertical width of the sector.
7. Use the scrollwheel to set [START] and
[LENGTH], referring to the example be-
low. Spin the scrollwheel to set and
push it to confirm.
• [START]: Distance from reference
point to sector
• [LENGTH]: Vertical length of sector
3.5.3 How to select the external radar (image source) to use
The dual radar display works best with two FAR-3xx0 radars. Other makes or models
can be used, however performance may vary.
1. From the [RADAR INSTALLATION] menu, select [2 SCANNER], [6 DUAL RA-
DAR SETTING].
2. Select [4 EXT RADAR].
3. Select required radar no. (Only the numbers of radar set on the [RADAR INSTAL-
LATION] menu are valid.)
Note 1: The dual radar will not function if a radar incompatible to the dual radar
function is selected.
Note 2: The dual radar display is designed to be used with two FAR-3xx0 series
radars. Other makes or models can be used, however performance may vary.
4. Press the MENU key to close the menu.
3. SETTINGS AND ADJUSTMENTS
Width of sector
ANGLE
(Example: 100°)
<Example> START:
LENGTH: 02.00 nm
START
(Example: 130°)
START START
LENGTH LENGTH
01.00 nm
3-5