Dvi-Rgb Conversion Kit (For Vdr Connection) - Furuno FAR-2117 Installation Manual

4. INSTALLING OPTIONAL EQUIPMENT
4.3

DVI-RGB Conversion Kit (for VDR connection)

This information provides the procedure necessary for the installation of the DVI-RGB
conversion kit. This kit is installed in the processor unit to enable connection of a VDR
(Voyage Data Recorder) or RGB monitor to record radar pictures into a VDR. When
changing the D-sub 15P of the RGB cable to the BNC connector, use the BNC connector
converter described on page 4-17. This RGB output complies with the image test defined in
the VDR test standard, IEC 61996.
Name: DVI-RGB conversion kit
Type: OP03-180-2
Code no.: 008-536-070
Resolution: Outputs RGB with the resolution of DVI input.
Display unit
MU-201CR
MU-231CR
Output signal specification:
See packing list for contents. Refer to the figure below for modification.
M3x8
6 pcs
SQ-35
Spacer
6 pcs
Spring washer
Fixing
holes
4-12
Resolution
1024x1280
1024x1365
Video; 0.7Vp-p, 75Ω termination, positive polarity
Horizontal sync signal; TTL level, negative polarity
Vertical sync signal; TTL level, negative polarity
J4
(6 pin)
03-2094
03-2092
03-2093
M3x8
4 pcs
J1
(13 pin)
Boss
RGB video output
To external RGB monitor or
BNC connector converter
for VDR connection (see
page 4-17).
DIP switch setting (S-1#1)
OFF
ON
DVI-RGB Conversion board
(SLB-FRN4-A)
J3
J9
(10 pin)
J615
RGB-BUFF board*
(03P9229B)
J2
J3
(3 pin)
RGB Cable
(User supply)
Ferrite core
Ferrite core side: Connect to DVI-D port on
the upper part of the processor unit.
*Indepent of the MAIN board.
DVI video input
DVI cable
03P9342 board
D-sub 15P
Female
Clamp copper tape
section by cable clamp.