Furuno FAR-3220-NXT Installation Manual page 63

2.6.2 MC-3010A/3020D/3030D
• MC-3010A: Inputs analog signal. To use MC-3010A as current input, connect short
pins to each terminals.
• MC-3020D: Inputs digital signal (8ch contact input). Contact or voltage input is se-
lectable (contact input requires short pins).
• MC-3030D: Outputs digital signal (8ch, normal open/close).
Fabrications
MC1.5-W-L600/1000/2000/3000 cable
(Input)
Vinyl tape Vinyl tape
(width: 10) (width: 10)
MC1.5-W-L600/1000/2000/3000 cable
(Output)
Vinyl tape Vinyl tape
(width: 10) (width: 10)
MPYC-12 cable (MC-3030D)
Not used: Cut with 50, Not used: Cut with 50,
and wind tape to insulate. and wind tape to insulate.
30 30 120 120
Shield Shield
(fold back) (fold back)
Core: 6 Core: 6
30 30 100 100
Shield Shield
(fold back) (fold back)
Core: 6 Core: 6
125 125
80 or 80 or
more more
85 85
Core: 6 Core: 6
TTYCSLA-1 (MC-3010A)
80 80
Vinyl tape Vinyl tape
(width: 10) (width: 10)
Pass drain wire through
shrink tubing (local supply),
then attach crimp-on lug
(pre-attached in unit).
TTYCS-1 (MC-3010A)
80 or 80 or
more more 30 30
Shield Shield
(fold back) (fold back)
Vinyl tape Vinyl tape
(width: 10) (width: 10)
MPYC-12 cable (MC-3020D)
80 or 80 or
more more
Not used: Cut with 50, Not used: Cut with 50,
and wind tape to insulate. and wind tape to insulate.
2. WIRING
60 60
Core: 6 Core: 6
60 60
Core: 6 Core: 6
60 60
135 135
95 95
Core: 6 Core: 6
2-33