Installing The Instrument - Furuno FI-301 Operator's Manual

2.1

Installing the instrument

Place the adhesive drill template on the desired location for the instrument. Drill
1
the 2 holes using a 5 mm ( / ") drill for the two pin bolts. Use a 63 mm (2½ ") hole
4
saw to machine the clearance hole for the instrument connection socket. Remove
the template.
Screw the two pin bolts to the instrument
Put the instrument in place
Screw the two nuts from the back
Note! The two nuts must just be tighten by hand
Run the Nexus Network cable from the Server
to the instrument.
If you want to cut the Nexus Network cable to
length, disconnect 4-pole jack plug and cut the
cable. Peel off about 35 mm (1,4") of the cable
insulation. Remove about 6 mm (1/4") from the
3 isolated wires (the 4th wire is an earth /
screen). Attach the 4 cable protectors to the
wires using a pair of flat pliers.
Connect the 4 cable protectors to the 4-pole
jack plug as shown. Apply silicon paste on all
locations as shown.
Silicon paste
Note: Must be done to avoid corrosion.
13