Table of Contents
Advertisement
12.5.8 C64 (WIA)
Select from 5 functions. (WIA) is the factory setting.
Select the function to be displayed as main-function under WIND.
The optional analogue wind instrument will display the same selection.
Select from 5 functions. (WIA) is the factory setting.
If the selected main-function is an angle, the sub-function will show the complimenting
angle, e.g. if (AWA) is selected as main-function, (TWA) will be shown as sub-function
and vice versa.
If the selected main-function is a wind speed, the sub-function will show the
corresponding angle, e.g. if (AWS) is selected, (AWA) will be shown as the sub-
function and vice versa for (TWS) and (TWA).
(WIA): True (TWA) or apparent wind angle (AWA).
Depending on what is set in C51, (ON = True, OFF = Apparent).
(AWA): Will display apparent wind angle (AWA) in this instrument independent of what
is set in C51.
(TWA): Will display true wind angle (TWA) in this instrument independent of what is
set in C51.
(AWS): Will display apparent wind speed (AWS) in this instrument independent of
what is set in C51.
The letters (AW) will be displayed to the right of the wind speed.
(TWS): Will display true wind speed (TWS) in this instrument independent of what is
set in C51.
The letters (TW) will be displayed to the right of the wind speed value.
12.5.9 C65 DAMPING (SEA)
Damping of wind information. Controls the response time of
wind changes.
To change damping, press SET. To select
damping level, press PLUS and select from: LOW) 1 sec,
(MED) 5 sec and (MAX) 22 sec. To store the selected value, press SET.
Factory value is (LOW), for use in calm sea. But if the sea is rough, you may want to
"stabilise" the readout on the display, then select MID or (MAX). Damping is set
separately for each instrument.
46
Advertisement
Table of Contents
